Category: JIS

Dimensions, mass and permissible variations of hot rolled steel sections (FOREIGN STANDARD)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2000

Rolling bearings — Insert bearing units (Foreign Standard)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2009

Wire ropes for aircraft control (Foreign Standard)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2012

Cross recessed head screws (Foreign Standard)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2017

Low-alloyed steels for cold heading — Part 1: Wire rods (Foreign Standard)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2010

Basic environmental testing procedures — Part 2: Tests — Test Q: Sealing (FOREIGN STANDARD)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2001

Rolling stock — Protective provisions against electrical hazards (Foreign Standard)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2009

Cold-rolled grain-oriented electrical steel strip and sheet delivered in the fully-processed state
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2019

Alternating-current watt-hour meters (for direct connection) — Part 1: General measuring instrument (Foreign Standard)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2009

Glossary of terms for valves
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/1984

Performance test for stationary polymer electrolyte fuel cell stack (Foreign Standard)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2008

Cylindrical gears — ISO system of flank tolerance classification — Part 1: Definitions and allowable values of deviations relevant to flanks of gear teeth (Foreign Standard)
standard by Japanese Industrial Standard / Japanese Standards Association, 01/01/2016